Fixes: - JWAC enhancement: Be able to show IP address and user ID with MAC address for authenticated JWAC user in logs, support roaming function for authenticated user between ports of the same VLAN - DES-3528P and DES-3552P support legacy PoE Powered Device (PD) - IPv6 ready logo phase 2 host mode - DHCPv6 client - IPv6 dual stack - IPv6 Management via Web, SNMP and Telnet - WAC enhancement: Support IPv6 clients for host-based WAC, support roaming function for authenticated user between ports of the same VLAN - DHCPv6 Relay - IPv6 Neighbor Discovery - Compound Authentication - Any mode (8021X, MAC, WAC, JWAC) - X+IMPB, MAC+IMPB, WAC+IMPB, JWAC+IMPB - Add port link change trap - Change the aging time granularity of ARP table to 1 minute-level user account - Memory utilization monitoring by SNMP, CLI & Web - Support Inter-VLAN routing feature: Dynamic host route, IPv4/v6 static route - Traceroute - L2 Protocol Tunneling - Per port, per VLAN MAC address learning control - ERPS - IMPB enhancements: IMPB 38, DHCPv6 and NDP Snooping - ah extension: D-link Unidirectional Link Detection (DULD) - Enlarge the IGMP/MLD Snooping Group to 1024 - Support RADIUS failover options when RADIUS times out: Use local database for authentication or Bypass authentication and assign client to port VLAN or guest VLAN or Block the client for a period of time - Add MAC per VLAN authentication display function. - Add MAC timer setting function. - DHCPv6 packet cannot be filtered by ACL - When relaying the DHCP request across two or more DES-3528/52, and all these switches are enabled with DHCP relay, clients cannot get the IP correctly - The status of MAC address in FDB will be changed from Permanent to UnBlockByMBA after the host is authenticated by MAC While it shouldn’t be changed - Switch may get into exception mode when running over 5 hours with JWAC concurrent users always over 120 - Sometimes the status of authenticated JWAC clients will be back to “JWAC_Authing” if the clients are some particular HP models with Vista OS - Port list information cannot be saved in configuration file for the command: "config ddress_binding ip_mac ports <portlist> state enable ipv6" - The drop packet counter will increase when receiving ICMPv6 packet - Configuration cannot be saved via Web UI when using Linux + Firefox 359 - When 8023x flow control is enabled, the switch does not count dropped packets - It is required to create an account 'enable' when using the command “enable admin”
Скачать